How to lubricate Treadly's belt?

We recommend lubricating the belt in an easy to clean area such as a tile floor or a non-carpeted surface.

  • Please make sure your Treadly is unplugged, and the handrail is down.
  • Turn the Treadly on its side (use a soft surface like a towel to lean the Treadly on to avoid any scratches or damage to the side) and use the lubrication bottle that was provided with your unit.
  • Lubricate the 'inner' portion of the belt (the underside of the belt, not the part you walk on).
  • Apply a line of lubrication across the width on the belt back, middle and front portion of the blet). 
  • wait 30 seconds before putting the unit to let the oil "slide" down the inner belt. 
  • Repeat the process on the other side as well.
  • Once finished, place the Treadly back on the ground, and plug the Treadly back in.
  • Begin slowly walking on the belt to be sure the lubrication is equally distributed along the inner belt.

 

 

 

 

 

 

 

Was this article helpful?
0 out of 7 found this helpful

Comments

4 comments

  • There are no instructions on how to get under the belt to lubricate it. You can't just lift it because you can't get to the edge. A video would help.

    1
  • To be clear, tipping over the Treadly on it's gives only access to the underside of the treadmill. Lubrication in underside. So we don' t have to adjust belt or do anything to get to under the belt above the deck where we walk . Is that correct?. I agree a video would be nice.

    2
  • In this description, it recommends applying a line of lubricant. I another section, it states: When lubricating, 7oz (1-2 drops) on each section of the belt (front, middle and back) is enough. Over lubricating might interfere with the engine's ability to pull the belt properly.

    Should it be a continuous line of lubricant or one or two drops in the front, middle and back. Please clarify.

    joe

    0
  • Can you please create a video on how to lubricate the belt. That would be really helpful.

    Thank you

    Gina

    0

Please sign in to leave a comment.